• Suitable for environments where long-term lighting is not required, such as stairs, bathrooms, corridors, hallways, lanes, etc.
• Convenient to use in the bathroom to control lights automatically on walking in.
• Using the automatic PIR motion sensor which uses an infrared sensor and illuminance sensor, when a person walks into a defined detectable area, the switch turns ON and turns lights on for the time delay set as long as it detects human motion. After the person walks out and after the time delay, the lights will automatically turn Off.

Specifications:

• Rated Voltage: 230V~ 50Hz
• Load Type: Various lamps: incandescent lamp, traditional bulbs, electricity-saving/ CFL Lamps, etc.
• Load Power: 500VA
• Start illuminance: 0~120 lux adjustable
• Time delay switch-off time: 15sec – 300sec adjustable

Features:

• This product is an auto-control device based on an infrared sensor and illuminance sensor, which controls load switching. The switch will enter the state of time-delay control as long as any movement occurred in its detection region, and the environmental illuminance is lower than the default value.
• The switch will repeat time-delay if it detects human activities again during delay period and will be shut down according to the default delay time till people leave.
• Good solution to saving electricity in places where long-term lighting is not required, as the lights will turn on only during the presence of a human or animal.

Note:

• Please have professional electrician assemble the wiring
  L1: Live wire      L2(N): Neutral Line      Arrow: Load
• When a single switch connected to several loads (eg: many incandescet lamps in parallel use), the total load power should be far lower than the rated ultimate capacity of the switch, otherwise it will be damaged.
• The switch will turn into undetectable state in the following three situations:
  • Room temperature is close to body temperature.
  • People standing still.
  • in bright environment.
• The switch will turn into “On” state by mistake in the following three situations:
  • Close to strong station/ transducer/ giant motor.
  • Blew by airflow of air-conditioning/ electromagnetic environments like broadcasting/ heating/ humidifier.
  • Wide sway of large potted plant/ curtain.
• Photosensitivity will respond about one minute later after adjusting the “Photosensitivity” knob.

Wiring Diagram:

Please ask a professional electrician to assemble the product, any mistake could lead to damage to the product.

Special Hints

• Switch off main power before installation or disassemble.
• Installation/ disassembly should be carried out by a licensed electrician or similarly qualified person.
• Select right voltage and current for its normal function at rated conditions according to electrical regulation.
• Please use incandescent light, electricity-saving lamp and ballast lamp in frequent use of places like hall, stairs,  corridor, toilet, bathroom, etc. Please note the frequent switch will reduce the lifetime of a lamp.
• Do not use this product in very wet environments.
• The housing works as a protection to the inside components during the installation. The wires in the mounting box may cause short-circuit if there is no housing protection. Please do not remove the housing during the installation.